Quiz Question!!

[raybkk]

http://nutechracingforum.com/vb/picture.php?albumid=5&pictureid=13

What is the above??

Tik Tok Tik Tok..........


Yes, you saw that right! Its a Steering Servo washer to lift the Throttle servo!!!

Very disappointed.....

If it would have been round at least it would have made sense! But using scrap parts to fill gab is just so not on especially if you are a company who would like to stand out of the rest!!

No idea what Foxy was doing when testing this car!!!

[jesi]

yeah, i did remove throttle servo and did not notice these washers at the moment.

I did move car in table at later in same day, then i did found these washers, when they droped from servo mount.
At that moment, bout whole car was in parts on my table and i did know where washers goes...

I did read user manual many times, and did not find where those washers goes.
In manual, mountings etc is not same what did in my TB2.


Okay, that is not nice and good looking, but it works and maybe nutech will send proper parts to that? :)

[raybkk]

yeah, i did remove throttle servo and did not notice these washers at the moment.

I did move car in table at later in same day, then i did found these washers, when they droped from servo mount.
At that moment, bout whole car was in parts on my table and i did know where washers goes...

I did read user manual many times, and did not find where those washers goes.
In manual, mountings etc is not same what did in my TB2.


Okay, that is not nice and good looking, but it works and maybe nutech will send proper parts to that? :)

I would not have known should the servo's have lasted longer.

But anyways, am now putting all my own gear in as the gear with it is just not good enough.

Hopefully I get it on the track by tomorrow.