Kill switch in stock radio?

[churre99]

hello!somebody can tell me, if I can install a picco 3rd channel kill switch, in the stock radio of the tb2.thanks

[Pipeous]

the kill switch you would need is the killer rc v2 as it works with a 2ch radio. I just ordered 2 from rckillswitch.com myself for my nutech's

[mooman007uk]

my nutech handset was 3ch

[churre99]

thank you for the answers, my receiver has three channels, I lack to know if the radio has them, I will install it I will already count you.regards:confused:

[Pipeous]

my rx has 3 ch and my radio has 2. on the manual page the rc came with, it shows 3 type. mine is the type with the dials on the left to set dual rate and end points. there is also a basic model with just servo direction switches, and another with an lcd display.

I tested the v2 switch with the dial epa type radio tonight and as long as you use it with a Y cable off steering ch 1, it is fine. I tested it with a number of radios and that was actually the only radio it worked with that I have. I tried it with 3 radios. My cheap multi model 2.4 ghz, one came with dirt bike and the nutech one.

[churre99]

hello boys, regrettably for my:beat dead horse:, I should say that the picco kill swich, is not worth in the radio of stock of the tb2, the third channel sends current, but it detects as if the radio was out, and if I place it in the 1 or 2 channel, when rotating to a side or when braking for the motor.I will have to prove another thing.regards

[Pipeous]

That is why I said the rckillswitch v2 with the stock radio. to kill the engine you have to turn off the radio. it's made specifically for 2ch radios. and it won't work if the radio has a built in failsafe... so it won't work off ch 2.