? for Nutech

[cabbie]

Can I have the correct measurement in length from hole centre to hole centre of the front A arms please, I understand there are a few arms that are too short (mine are 137.5mm) and bind the steering etc.

If anyone has a MT with the correct length arms IE: free steering etc could you measure from the chassis plate out to the end of the arm so I can check mine again.

Thanks cabbie.

[cabbie]

Mine measure 131mm to the hub carrier pin with a rule against the alloy diff brace.

I had the camera at a slight angle but it's 131mm to the pin centre.

http://i7.photobucket.com/albums/y254/cabbie1/DSCF0001-24.jpg

[Nutech Ethan]

http://i755.photobucket.com/albums/xx199/nutechracing/Mtfrontlowerarm.jpg?t=1269916241